SUSPENSION & AXLE Suspension Conversion Kits Defender 4-Corner Air Suspension Conversion Kit How about modifying your Defender with improved on-road behaviour for daily use and the ability of increased ground DA9110 Defender 110 & 130 clearance when venturing off-road? Compatibility When your Defender is fitted with the standard coil suspension, the ride is a compromise It is important you abide by this compatibility between off-road ability, load carrying and normal road use. By using a full air suspension kit,list in order to protect the components in the ride quality is improved and vehicle height can be altered by moving to a pre-set relevant air suspension kit. Any parts warranty claim to your needs. Vehicle height and wheel travel then stays in the optimal working range for would be void if this criteria is not followed. suspension performance and comfort at all legal loads*. Bump Stops - Minimum height from chassis 70mm. Bump stop spacers are provided to Benefits of Full Air Conversion meet this criteria when using standard > Improved vehicle stability and handling under all loaded conditions Land Rover factory bump stops. > Increased comfort and enhanced driving experience Anti-roll Bars - Passive front and rear anti-roll > Fully adjustable heights with Intelligent controls bars must be fitted. > Optimized geometry Shock Absorbers - Front shock absorber > Constant ride height under all loaded conditions up to vehicle full GVW* maximum length - 545mm. Rear shock > Easily installed and user friendly system absorber maximum length - 535mm High quality materials are used to give you the most reliable kit for your Land Rover. Bespoke air spring units are used in conjunction with a turret setup & electronic control system. Electronic components have been durability tested and in many cases are shared with those fitted to many European cars for factory fit air suspension. The compressor from AMK is very robust with low noise & vibration. The kit comes complete with full instructions and all the necessary parts, it’s easy to install and requires minimal drilling during fitment. Kit Features > Constant ride height* > Increased comfort > Improved stability & driveability > Pre-set heights for electronic control system • Access - Low for easy entry/exit • Ride height - Normal road use • Off-road > Additional tilt features available > Multi-axis horizon levelling add-on feature available on request Technical Specification Wheel travel /home/webapps/asp_fr/data/asp/publications/border-holdings/britpart-accessory-catalogue-20th-edition180mm Off-road position +40mm Access position -60mm *Please refer to Land Rover for Defender official payload capability. Photo by Luis Gutierrez 183